Advertisement
Quick Links
INSTALLATION MANUAL
Cab-Mate Flex (from Cab-Mate
Connect)
Document ID:IM-CMFX
Last Updated: October 08, 2021
Pedigree Technologies recommends using a professional installer for optimal
results. Please let your Pedigree Technologies representative suggest a provider if
you need help with your hardware installations.
PedigreeTechnologies.com | Support: (701)-499-0022
Advertisement
Related Manuals for Pedigree Technologies OneView Cab-Mate Flex
Summary of Contents for Pedigree Technologies OneView Cab-Mate Flex
- Page 1 Cab-Mate Flex (from Cab-Mate Connect) Document ID:IM-CMFX Last Updated: October 08, 2021 Pedigree Technologies recommends using a professional installer for optimal results. Please let your Pedigree Technologies representative suggest a provider if you need help with your hardware installations. PedigreeTechnologies.com | Support: (701)-499-0022...
-
Page 2: Required Equipment
INSTALLATION MANUAL Prerequisites Required Information [*needed for final activation of hardware - see last page] • Name of asset (ex: Propane Truck #20) • Detailed information about the asset (year, make, model, VIN, license plate, etc.) • State, area, organization, or group the asset belongs to (ex: North Region, MN tankers, etc.) •... -
Page 3: Before You Begin
Cab-Mate Connect to Cab-Mate Flex Before You Begin TURN TO THE LAST PAGE - WRITE DOWN THE REQUIRED INFORMATION!!! • Decide where the hardware components will be located. If necessary remove any dash panels with removal tool. • Must be within reach of the diagnostic cable to be installed. •... - Page 4 Plug the cable from the previous Cab-Mate Connect into the 6 pin port on the Cab-Mate Flex. STEP FOUR Call Pedigree Technologies support to confirm installation before replacing any of the dash panels you may have removed during cable installation. Install Confirmation: 701-499-0022 You will be prompted for the following information during the set up process •...
-
Page 5: Alternative Installation
Cab-Mate Connect to Cab-Mate Flex Installation Steps, Continued Alternative Installation STEP ONE Remove all cables from the back of the previously installed 3640 LMU. You will re-attach the diagnostic cable in a later step, but all other connected cables can be removed. STEP TWO Place the empty 3640 LMU into the bracket on the Cab-Mate Flex cradle assembly and snap into place... - Page 6 Cab-Mate Connect to Cab-Mate Flex Connect Diagnostics Cable to Cradle STEP FOUR Plug the canbus cable that you removed from the LMU in an earlier step, into the 16 pin port on the 3640 LMU (the only open port). 16 Pin Connector from canbus cable STEP FIVE (If not already pre-assembled) Connect the 6 pin plug (smaller of the two plugs) from the LMU...
- Page 7 Tablet in Cradle/LMU Cradle/LMU STEP SEVEN Call Pedigree Technologies support to confirm installation before replacing any of the dash panels you may have removed during cable installation. Install Confirmation: 701-499-0022 You will be prompted for the following information during the set up process •...