Advertisement
Operation
Operating Instructions
Icon
Function
A
Power
B
Heat
Temperature
C
D
Flame Speed
E
Colour Themes
F
Brightness
G
Flame
H
Timer
10
Description
Press to turn unit Off or On.
Unit Off
Press to turn everything Off. Press again to turn unit On with previous settings.
Unit On
Press to turn unit On with previous settings.
- If the flame effect was On, the flame will turn on and the previous heat setting will
be activated (On or Off). The display will show the current heater temperature set-
ting and after 2 seconds displays the room temperature.
- (Remote only) If the flame effect was Off, the previous heat setting will be activat-
ed (On or Off).
- (Panel only) If the flame effect was Off, the flame will turn on and the previous heat
setting will be activated (On or Off).
Heat On
Press to turn heat On (indicated by 1 short beep). The display will show the current
heater temperature setting and after 2 seconds displays the room temperature. Use
the Temperature icon to change the heater temperature setting.
Heat Off
Press to turn the heat Off (indicated by 1 short beep).
NOTE: After the heater is switched off, the fan will continue on for 60 seconds before
turning off.
Press multiple times to raise the heater temperature in 1°F (1°C) increments. The
display will show the current temperature. The temperature range is 62°-78°F (17°-
26°C).
This feature is active whenever the heat is enabled.
Press multiple times to toggle through flame speeds (minimum, medium, maximum).
The display will show the current speed number (F1, F2, F3 respectively).
Press multiple times to change the media and flame base colours. This feature is active
only when the flame effect is on. The display will show the theme (t0, t1, t2, etc.)
XHD28L, XHD26L or XHD23L (Log unit) themes:
- Theme t0 - no flame
- Theme t1 - Natural (flame base off)
- Theme t2 - Red highlights (flame base red/orange)
- Theme t3 - Blue highlights (flame base blue)
Press to change the fame and logs brightness. Display will show b3, b1, b2 respec-
tively.
•
High
•
Low
•
Medium
Press to turn the flame effect on. Press again to turn the flame effect off.
Press multiple times to change the sleep timer by 0.5 hours from 0.5-8 hours before
turning off. Press again and the remaining time on the timer displays.
Advertisement
