DETAILED SET-UP GUIDE BATTERY INSTALLATION A. REMOTE TEMPERATURE TRANSMITTER 1. Remove the battery cover. Place your thumb over the two air-vent slots on the face of the Remote Temperature Transmitter, push down gently, slide battery cover down and off. 2. Observing the correct polarity, install 2 AAA batteries.
Page 5
STATION 1. Remove battery cover. Pull up and out from the slot located in the central position of the battery cover. 2. Observing the correct polarity, install 2 AAA batteries. The batteries will fit tightly (to avoid start- up problems make sure that they do not spring free during installation).
Page 6
LCD segments should light up. Also within 3 minutes, the Outdoor Temperature should be displayed in the OUTDOOR LCD. If any of this does not occur, remove all batteries and install them again—carefully observing the polarity. C. LOW-BATTERY & BATTERY REPLACEMENT FEATURES When the batteries become weak in the Weather Temperature Station, a low...
INDOOR LCD FORECAST LCD OUTDOOR LCD INDOOR TEMPERATURE The Weather Temperature Station monitors the temperature within its immediate proximity, and displays this temperature (°F or °C) in the INDOOR LCD. The temperature is monitored as soon as the batteries are installed.
The weather forecasting feature is estimated to be 75% accurate. The weather forecast is based solely upon the change of air pressure over time. The WS-7032U averages past air-pressure readings to provide an accurate forecast— causing a necessity to disregard all weather forecasting for 12-24 hours after the unit has been set-up, reset, or moved from one altitude to another (i.e.
Page 9
Sunny—indicates that the weather is expected to improve (not that the weather will be sunny). Sun with Clouds—indicates that the weather is expected to be fair (not that the weather will be sunny with clouds). Clouds with Rain—indicates that the weather is expected to get worse (not that the weather will be rainy).
Page 10
and gradual to register. WEATHER TENDENCY ARROWS Other possible displays in the FORECAST LCD are 2 weather tendency arrows, one that points up (under the forecast icons) and one that points down (above the forecast icons). These arrows reflect current changes in the air pressure.
II. OUTDOOR TEMPERATURE The Weather Temperature Station receives the outdoor temperature (°F or °C) from the Remote Temperature Transmitter, and the temperature appears in the OUTDOOR LCD. The Remote Temperature Transmitter makes a temperature update every 1 minute, and transmits a new temperature to the Weather Temperature Station 3 times every 10 minutes.
Page 12
facing wall. The sending range is 80ft (25m)— obstacles such as walls, concrete, and large metal objects can reduce the range. Place both units in their desired location, and wait approximately 10 minutes before permanently mounting to ensure that there is proper reception. Temperature Station should display a temperature in the OUTDOOR LCD within 3 minutes of setting-up.
Page 13
desired location. Through the three screw holes of the bracket, mark the mounting surface with a pencil. 3. Where marked, start the screw holes into the mounting surface. 4. Screw mounting bracket onto the mounting surface. Ensure that the screws are flush with the bracket. 5.
Page 14
Weather Temperature Station can receive the signal. THE WEATHER STATION The Weather Station can be mounted on the wall with the use of a wall hanging screw (not included). A. WALL MOUNTING 1. Place a screw (not included) into an...
TROUBLESHOOTING Problem: No outdoor temperature is displayed. Solution: 1) Remove all batteries—wait 30 seconds—then reinsert into transmitter first, then into the station. 2) Place transmitter closer to station. 3) Be sure there are no obstructing objects. 4) Be sure all batteries are fresh. Problem: The LCD screens are faint/dim.
MAINTENANCE AND CARE INSTRUCTIONS • Extreme and sudden temperature changes, vibration, and shock should be avoided to prevent damage to the units. • Clean displays and units with a soft, damp cloth. Do not use solvents or scouring agents; they may mark the displays and casings.
SPECIFICATIONS Temperature measuring range Indoor: 32°F 104°F with resolution: (0°C to 40°C with 0.1°C resolution). displayed if outside this range. Outdoor: -21.9°F to 157.9°F with 0.2°F resolution: (-29.9°C to 69.9°C with 0.1°C resolution). displayed if outside this range. Temperature checking intervals Indoor: Every 10 seconds.
Page 18
Power Source Weather 2 x AAA, 1.5V (IEC LR3) Station: Transmitter: 2 x AAA, 1.5V (IEC LR3) Dimensions (L x W x H) Weather 2.95 x 0.83 x 7.28in. (75 x 21 x Station: 185 mm) Transmitter: 2.32 x 0.83 x 2.56in. (59 x 21 x 65mm)
Contact La Crosse Technology immediately upon discovery of any defects covered by this warranty. Before sending the Weather Station in for repairs, contact La Crosse Technology. The Weather Station will be repaired or replaced with the same or similar model.
Page 20
FOR PUBLIC INFORMATION. THIS PRODUCT IS NOT A TOY. KEEP OUT OF CHILDRE’S REACH. This warranty gives you specific legal rights. You may also have other rights specific to your State. Some States do no allow the exclusion of consequential or incidental damages therefore the above exclusion of limitation may not apply to you.
Page 21
e-mail: support@lacrossetechnology.com (warranty work) sales@lacrossetechnology.com (information on other products) web: www.lacrossetechnology.com All rights reserved. This handbook must not be reproduced in any form, even in excerpts, or duplicated or processed using electronic, mechanical or chemical procedures without written permission of the publisher.