Advertisement
Available languages
Available languages
PRODUCT ASSEMBLY
1
Spring Latch
Turn the Stand Mixer to "0" (OFF) and
then Unplug.
To attach the Bowl: Fit the Bowl
Supports over Locating Pins and press
down on back of the Bowl until Bowl Pin
snaps into Spring Latch.
3
To attach the Accessory: Slip the
accessory onto the shaft. Turn to hook it
over the Pin on the shaft.
IMPORTANT: If the Bowl is not securely snapped into place, it will be unstable and
wobble during use.
5
To raise the Bowl: Rotate the
Bowl-Lift Lever to the straight up
position. The Bowl must always be in the
raised position when mixing.
W11519607D.indb 5
W11519607D.indb 5
Locating Pin
Pin
2
To Remove Bowl: Place Bowl-Lift Lever
in the down position. Grasp Bowl Handle
and lift straight up and off Locating Pins.
4
To Remove the Accessory: Turn Stand
Mixer to "0" (OFF) then unplug. Press
accessory upward and turn to the left. Pull
down the accessory from Beater Shaft.
6
Test the Beater to Bowl Clearance: Turn
Stand Mixer ON and test each speed,
making sure the beater does not touch
the Bowl during operation. If the Beater
is too far away from the bottom or is
hitting the Bowl, proceed to next step to
make adjustments.
5
3/28/2022 9:52:25 AM
3/28/2022 9:52:25 AM
Advertisement
