Properties; Initialize; Properties Initialize - La Crosse Technology WS-2010 Software Manual

Properties

Initialize

The "Initialize interface" window can be used to define the interval period for
saving the measured values in the PC interface and the number of temperature/
humidity sensors supported (9 or 16). Intervals between 1 minute and 1 hour can
be set for saving the measured values. The default interval period is 5 minutes.
The maximum number of measured values which can be saved is not only de-
pendent on the interval but also on the number of sensors connected (9 or 16).
With a storage interval of 10 minutes and 9 temperature/humidity sensors, the
recording time exceeds one week. If the memory is full, the respectively oldest
data is overwritten according to the principles of the ring memory. The stored
data should, therefore, be read out from the PC and into the required file in good
time, according to the set interval.
The following table illustrates the connection between the number of sensors
supported, the selected interval and the maximum storage period. Each dataset
requires 30 or 56 bytes.
Sensors
9
9
16
16
request appears. If in doubt, read out the weather data available before initiating
changes.
Interval (minutes)
5
10
15
30
Maximum storage period (days)
Note:
The interval and number of
sensors involved should
be selected when the
weather
commissioned an not
subsequently adjusted, if
possible, because all data
in the radio interface is lost
following modification!
Therefore, before the
interval or number of
sensors connected can be
changed, a conformation
3.5
7
5
10.5
station is
41