Advertisement
SUPPLIED TEST SWITCH/
INDICATOR LIGHT
SW INDICATOR
UL SWITCH
COVER
Mounting Height: This product meets or exceeds the NFPA minimum light requirements
with all loads, down to the smallest rated lamp load, at heights up to 28.4ft (8.4m).
Many factors influence emergency illumination levels, such as the lamp load selected,
93071446
luminare design, and environmental factors, therefore end use verification is necessary.
PLASTIC
For field installations,when the attached luminaire is mounted at heights greater then
TUBE
28.4ft (8.7m), the level of illumination must be measured in the end application to ensure
the requirements of NFPA 101 and local codes are satisfied.
Step 5.
Select correct wiring diagram to connect the emergency driver to the LED load, AC LED driver and Switch. Make sure all connections are in accordance with the National
Electrical Code and any local regulations.
Step 6.
Install in a visible location the labels "CAUTION" & "STATUS" (see illustration 4).
Step 7.
After installation is complete, supply AC power to the emergency ballast and join the converter battery connector.
Step 8.
At this point, power should be connected to both the AC driver and the emergency driver, and the charging indicator light should illuminate indicating the battery is
charging.
Step 9.
A short-term discharge test may be conducted after the emergency ballast has been charging for one hour.
Step 10.
Charge for 24 hours before conducting a long-term discharge test. Refer to "Operation" section below
Note: Make sure the necessary branch circuit wiring is available. An unswitched source of power is required.
The emergency ballast must be fed from the same branch circuit as the AC ballast.
4
EMERGENCY DRIVER AND AC DRIVER MUST BE FED FROM THE SAME BRANCH CIRCUIT
TYPICAL SCHEMATICS ONLY. CONSULT THE FACTORY FOR OTHER WIRING DIAGRAMS
EMERGENCY BACK-UP & AC DRIVER
RED
RED
WHT/RED
PLD10
BLACK
EM LED
VIOLET (+)
BROWN (-)
DRIVER
WHITE
WHT/BLK
BLUE
YEL/BLK
YELLOW
LED LOAD
AC DRIVER
EMERGENCY BACK-UP ONLY
RED
RED
PLD10
BLACK
EM LED
VIOLET (+)
BROWN (-)
LARGE
BUSHING
PLASTIC
TUBE
TY-WRAP
93071446
SMALL
BUSHING
ILLUSTRATION 3
3
CONVERTER BATTERY CONN.
WALL SW
VIOLET (+)
BROWN (-)
LED (+)
LED (-)
AC DRIVER (-)
AC DRIVER (+)
BLACK
WHITE
CONVERTER BATTERY CONN.
VIOLET (+)
BROWN (-)
EM DRIVER
TYPICAL LED
LIGHTING
FIXTURE
WIRING
EMERGENCY BACK-UP, AC DRIVER
HOT
PLD10
EM LED
TEST SW/LED INDICATOR
DRIVER
COMMON
LED LOAD
AC DRIVER
HOT
TEST SW/LED INDICATOR
"STATUS"
LABEL
LED mtg plt
(lens not shown)
ILLUSTRATION 4
2
REV
DATE
1
4/28/16
AND STEP DIMMING
RED
CONVERTER BATTERY CONN.
RED
BLACK
VIOLET (+)
VIOLET (+)
BROWN (-)
BROWN (-)
WHT/RED
WHITE
WHT/BLK
BLUE
YEL/BLK
YELLOW
LED (+)
LED (-)
AC DRIVER (-)
AC DRIVER (-)
AC DRIVER (+)
AC DRIVER (+)
WHITE
LINE 1
LINE 2
SWITCH
INDICATOR
93071865
"CAUTION"
LABEL
1
RECORD
DE
EC-160127003
AL
HOT
TEST SW/LED INDICATOR
COMMON
SW 1
HOT
SW 2
Advertisement
