Nexxt Solutions Professional Series Quick Start Manual

Dual hinged wallmount enclosure

Hide thumbs Also See for Professional Series:

Fully assembled

dual hinged wallmount enclosure

ProfessionalSeries

NPC-P6U65B

NPC-P12U65B

NPC-P9U65B

NPC-P15U65B

NPC-P18U65B

Table of Contents

Need help?

Do you have a question about the Professional Series and is the answer not in the manual?

Page 1 Fully assembled dual hinged wallmount enclosure NPC-P6U65B NPC-P12U65B NPC-P9U65B NPC-P15U65B NPC-P18U65B ProfessionalSeries...
Page 2 1. Introduction Thank you for purchasing the welded swing frame wallmount cabinet system from Nexxt Solutions. This enclosure is made up of heavy-gauge steel and a sturdy mounting frame. It also features a tempered-glass front door, with lockable access to keep network gear and communication cabling safe and properly organized.
Page 3 2.Preliminary steps • Prior to installing this product, you must read all instructions thoroughly. White plastic bushing Pre-installed • Keep these instructions handy in an easily accessible location for future reference. • A clean, flat, level, protected floor area should be provided for the enclosure assembly to prevent damage to parts.
Page 4 4. Wall-mounting procedure Securing the enclosure Warning Confirm that the wall is strong enough to support the weight of the enclosure 1. Unlock the pivoting frame and swing the body of the enclosure out with all the loads. Failure to follow these procedures may result in personal injury to expose the back of the structure.
Page 5 4. Then, connect the grounding cable to the left side panel on the rear section of the cabinet. Notes 5. Using the self-tapping screw, bind the grounding cable to the closest mounting hole on the left side horizontal beam. Note: fully-tighten the screws only after all the screws have been inserted.
Page 6 Notes Notes...

Npc-p6u65bNpc-p9u65bNpc-p12u65bNpc-p15u65bNpc-p18u65b