○ If the watch body or band becomes edged by corrosion etc. electricity ○ If the pins protrude from the band. * Immediately consult the retailer from whom the watch was purchased or SEIKO CUSTOMER SERVICE If you observe any allergic symptoms or skin irritation CENTER.
Immediately consult the retailer from whom the watch was purchased or SEIKO CUSTOMER SERVICE CENTER. b CAUTION Do not leave moisture, sweat and dirt on the watch for a long time.
Crown How to set the time (for models with two or three hands) There are two types of crowns, a normal crown and a screw down crown. Please check the type of the crown of your watch. Models with two hands Models with three hands Normal crown While...
● Time setting ● Date (Day of the week) setting The watch is provided with a date (day of the week) function and is so designed that the date Pull out the crown to the second click. changes once every 24 hours. Pull out the crown to the second click when the The date (day of the week) changes around 12 o’clock midnight.
(for models with a seconds hand: until it reaches one-second interval movement). Charge the watch using these times as a guide. * The required charging time slightly varies depending on the model of the watch. ● V111 / V114 / V115 / V116 / V117 Time required Time required for...
Power Source * Overcharge prevention function When the secondary battery is fully charged, the overcharge prevention function is automatically activated to avoid further charging. The battery used in this watch is a special secondary battery, which is different from ordinary There is no need to worry about damage caused by overcharging no matter how much the batteries.
Lumibrite Water resistant performance If your watch has Lumibrite Refer the table below for the description of water resistant performance of your watch before using. (Please look at P.24.) Lumibrite is a luminous paint that absorbs the light energy of sunlight and lighting apparatuses in a short time and stores it to emit light in the dark.
● Leather band Band • A leather band is susceptible to discoloration and deterioration from moisture, sweat and direct sunlight. • Wipe off moisture and sweat as soon as possible by gently blotting them up with a dry cloth. The band touches the skin directly and becomes dirty with sweat or dust. Therefore, lack of care •...
Page 10
B Type C Type While pressing the push buttons on both sides Remove the pin from the adjustment hole. of the flap, lift to open the clasp. Slide the band left and right, and insert the pin ● How to wear or take off the watch into the adjustment hole at an appropriate Push button length.
According to use conditions, the oil retaining condition of your watch mechanical parts may deteriorate, abrasion of the parts may occur due to contamination of oil, which may ultimately lead the • Contact the retailer from whom the watch was purchased or SEIKO CUSTOMER SERVICE CENTER watch itself to stop.
Specifications Caliber number V181 Basic watch with three hands (Hour, minute and seconds hands) 1. Features 2. Frequency of V114/V115/ V111/V117/ V147/V157/ 32,768 Hz (Hz= Hertz, cycles per second) Caliber number V137/V138 V187 crystal oscillator V116 V131 V158 Basic watch with 3.
Need help?
Do you have a question about the V111 and is the answer not in the manual?
Questions and answers