Linking; Dmx Configuration - Prolights Tribe GLOBE User Manual

3.6 LINKING

Several units may be interconnected in order to control all further slave units to the same effect of the
master unit.
1. Connect the DMX OUT of the master unit via 3-pole XLR cable to the DMX IN of the first slave unit.
2. Connect the DMX OUT of the first slave unit to the DMX IN of the second slave unit, etc. until all units
are connected in a chain.
POWER OUT DMX OUT
3.7 DMX CONFIGURATION (12 CHANNELS)
The GLOBE is equipped with a 12 channels DMX configuration.
The table on page 12 indicate the operating mode and DMX value.
• To set the DMX address, press the button MENU so many times until the display shows DMX CH.
• Press the button UP/DOWN to select DMX 12 CH, then press ENTER to confirm.
• Press the button MENU so many times until the display shows DMX Address.
• Press the button UP/DOWN to select the desired value 001-512.
• Press the button ENTER to confirm the setting.
• Set all driver bar to same DMX address.
• Press the button MENU so many times until the display shows Mix Display.
• Press the button UP/DOWN to set the value 1/2/3 respectively the first, second and third driver bar.
• Press the button ENTER to confirm.
Once the procedure is finished, you can control all the driver bars connected by a single DMX controller.
DMX SIGNAL
POWER
DMX IN POWER IN
POWER OUT DMX OUT
GLOBE
DMX SIGNAL
POWER
POWER OUT
DMX IN POWER IN
DMX OUT DMX IN
9
DMX SIGNAL INPUT
POWER INPUT
POWER IN
Fig.4