Advertisement
Available languages
Available languages
Installation Diagram
Power Source Connection
Access the back panel (power source cable) to the power supply which is equipped with circuit
breakers and grounding line (grid), and it is strictly prohibited that ground wire is connected to the
grid, otherwise bear your own consequences.
Electrode Polarity (see above picture)
Connect the quick plug with electrode holder to the positive terminal and then tightened them up
clockwise.
Workpiece Connection
Connect the quick plug with earth clamp to the negative terminal on the front panel below. And then
tighten them up. Access the earth clamp to the workpiece.
Warning!
It is forbidden to connect the workpiece to the welder with iron or other poor
conductors.
Operation Instruction
NOTES: The case protection class is IP21S. Finger or round bars especially metal rod must be less
than 12.5mm and it can not be inserted into the welder. Also you can not press it heavily.
1. Negative Terminal
5.High Temperature
9. Fan
NOTES: When the welder works for a long time, the high temperature indicator will light. This means the
inside temperature has exceeded its standard. And you must turn off the power immediately for a period
until it recovers.
* You have to wear canvas overalls and face mask to prevent from arc light and heat radiation.
*
Vibration screen should be laid out to prevent others from arc light.
*
Inflammable and explosive stuffs are not allowed to pile up. All the connections must be right,
reliable.
2. Positive Terminal
6. Knob
3.Power Indcaitor
7. Power Switch
4.
belt
8. Power Source Cable
Advertisement
