Advertisement
Available languages
Available languages
Symbol Chart
Note that only some of these symbols will appear on your model
Installation
Connection
The welder should be placed in dry and dusty surrounding where there is no corrosive
chemicals, flammable, explosive gases.
* Avoid direct sunlight and rain. And maintain the ambient temperature ranging from
-10℃ to 40℃.
*
The space of 50cm should be left around the equipment.
*
If indoor ventilation is not good enough, the ventilation exhaust device should be
installed
On
Off
Dangerous Voltage
Increase / Decrease
AC Auxiliary Power
Fuse
Amperage
Voltage
Three Phase
SMAW
GTAW
Wire Feed Function
Hertz (cycles / sec)
Frequency
Negative
Positive
Direct Current (DC)
Protective Earth
Line
Single Phase
Duty Cycle
GMAW
High Temperature
Welding Gun
Advertisement
