Advertisement
Quick Links
Advertisement
Related Manuals for Crolla NEXUS DUALFIX
Summary of Contents for Crolla NEXUS DUALFIX
- Page 1 Group: 0+, I, II, III Weight: 0-36kg Approval according to ECE R44/04...
- Page 2 For Installation with 3-point-belt or with ISOFIX (ISOFIX attachments and top tether) 1. This is a ‘Universal’ child restraint. It is approved to UN ECE regulation 44, 04 series of amendments, for general use in vehicles and it will fit most, but not all, car seats. 2.
- Page 3 For your child’s safety, please read these instructions carefully before use and keep • DO NOT carry this child restraint with a child in it. them for future reference. Failure to follow the instructions contained in this manual • DO NOT put anything other than the recommended soft goods in this child restraint could result in serious injury to your child.
- Page 4 Please follow the steps below for height adjustment of shoulder straps: Note: Fit the ISOFIX attachments guides with the ISOFIX To release the harness, press the red button attachments anchor points. The ISOFIX attachments guides to disengage the buckle. can protect the surface of the vehicle seat from being torn. They can also guide the ISOFIX attachments connectors.
- Page 5 4.5 Height Adjustment for Headrest and shoulder harnesses 4.5.1 Adjust the height of shoulder harnesses 4.5.2 Adjust the height of headrest Detach the snaps and remove the both two shoulder pads, take off the two metal sections of buckle from the shoulder straps. Stored the shoulder straps and buckle in their storage compartments...
- Page 6 4.7 The adjustment of ISOFIX attachments The ISOFIX attachments can be adjusted for many positions to fit the different position of ISOFIX low anchorages expending from car seat. Extend the ISOFIX attachments Step2 : Pass the waist belt over lap belt connectors to the longest by depressing on with rearward-facing mode guiding, and then engage the vehicle buckle...
- Page 7 IMPORTANT: Please remove the cushion for 9-months-old child. Step 5: Make sure that tether hook is securely attached to the anchorage fitting. with forward-facing mode Make sure that you have hear a “click” and the color of ISOFIX indicators show GREEN. Step 6: Pull the strap tightly.
- Page 8 ISOFIX and top tether. Step 2: Pass the waist belt over lap with forward-facing mode belt guiding through the child’s seat as shown in the picture. Step 3: Make sure that tether hook is securely attached to the anchorage fitting. with forward-facing mode Step 4: Pull the strap tightly.
- Page 9 Check the child seat regularly. The child seat should be replaced after an accident. Step 1: Push the child seat towards car seat backrest tightly. (See 4.7) Step 2: Place the child in the child restraint and check whether the shoulder belt guides are at proper height (see 4.5). Position shoulder belt through shoulder belt guide, pass waist belt through lap belt guidings.
Need help?
Do you have a question about the NEXUS DUALFIX and is the answer not in the manual?
Questions and answers