Advertisement
Quick Links
Advertisement
Related Manuals for Edimax Wake-On LAN Adapter
Summary of Contents for Edimax Wake-On LAN Adapter
- Page 1 Wake-On LAN Adapter Installation Guide...
-
Page 2: Fcc Compliance Statement
FCC COMPLIANCE STATEMENT This equipment has been tested and found to comply with the limits of a Class B computing devices, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful... - Page 3 Introduction The Wake On LAN (WOL) feature allows users to configure network adapters that are capable of “listening to” network packets even when the computer is turned off. In order for the Wake On LAN feature to work correctly, this network adapter must be connected to a power source even when the PC is turned off.
- Page 4 Specifications (1) Hardware requirement Ÿ Motherboard with 3-pin WOL connector. (Some computers may require you to change a setting in your computer’s BIOS or setup program to enable the WOL feature.) Ÿ ATX 2.01 power supply. Note : Install only one active WOL adapter per computer.
- Page 5 Installation 1. Unplug the PC, remove the cover, and disconnect the cables. 2. Unpack the NIC and 3-pin auxiliary power cable. 3. Choose an available bus master PCI slot. 4. Remove the backplate and insert the adapter into the empty PCI slot. 5.
- Page 6 Trouble-shooting n The PC can not boot up after installing the adapter. 1. Remove the 3-pin cable from the PC connector. 2. Boot up the PC, run setup program to configure the adapter as “Active Low”(Default setting is “Active High”) 3.
- Page 7 TRADEMARKS Copyright 1998 by Edimax Technology Co., Ltd. No part of this manual may be reproduced, transcribed, stored in a retrieval system, translated into any language or computer language without the prior written consent of Edimax. All brand and product names are trademarks and/or...