Advertisement
Quick Links
Installation and Operating Instructions
MODEL: MIFF7030AP
Tall A+ BUILT-IN Fridge Freezer
N.B. Picture shown for indicative purposes only!
Please read these instructions carefully before attempting to install or use this appliance.
It is advisable to keep these instructions in a safe place for future reference.
N.B. Should your appliance require attention, our service agents will not be able to book a
service call without your unique serial number which can be found on the last page of this
manual.
Advertisement
Related Manuals for montpellier MIFF7030AP
Summary of Contents for montpellier MIFF7030AP
- Page 1 Installation and Operating Instructions MODEL: MIFF7030AP Tall A+ BUILT-IN Fridge Freezer N.B. Picture shown for indicative purposes only! Please read these instructions carefully before attempting to install or use this appliance. It is advisable to keep these instructions in a safe place for future reference.
- Page 2 Introduction Thank you for choosing this Montpellier appliance. It has been designed to give years of trouble-free use provided it is installed and maintained correctly. Please read these instructions carefully before installing or using your appliance. It is advisable to keep your purchase and installation receipts with these instructions in a safe place for future reference.
- Page 3 Your 2 year Manufacturer's guarantee THIS DOES NOT AFFECT YOUR STATUTORY RIGHTS. montpellier Your new appliance carries a free guarantee which protects you against the cost of repairs during the first 24 months from date of purchase provided that: Any claim is accompanied by evidence of the model reference, model serial number and proof of purchase, such as a Sales Receipt, showing that the appliance was purchased within the 24 months prior to the date of claim.
- Page 4 Description of the Appliance A) Refrigerator compartment 6) Top freezer drawer B) Freezer compartment 7) Middle freezer drawer 8) Bottom freezer drawer 1) Thermostat 9) Ice tray 2) Refrigerator lamp and cover 10) Bottle Shelf 3) Refrigerator shelves 11) Door shelves 4) Crisper shelf 12) Egg holder 5) Crisper...
- Page 5 CONTENTS: Section 1. Installation Section 2. Safety Advice Section 3. Operating the Appliance Section 4. Maintenance...
- Page 6 Section 1. Installation IMPORTANT! This appliance must be left to stand in an upright position for at least 4 hours before being switched on for the first time. Remove all packaging and securing tape from the appliance. Wash the interior of the appliance with lukewarm water containing a small amount of bicarbonate soda (5ml to 0.5 litres of water).
- Page 7 Installation · Before installation, read the instructions carefully. · Fit the refrigerator/freezer in stable kitchen units only. · If necessary, reverse the door according to instructions. · Check the installation dimensions according to fig.C. The position of the joint between the unit doors must be level with the position of the joint between the appliance doors.
- Page 10 Section 2. Safety Advice Please read this booklet thoroughly before installing and switching on the appliance. The manufacturer accepts no responsibility for incorrect installation and usage. If this appliance is to replace an old refrigerator with a lock, as a safety measure break or remove the lock and/or door before disposal.
- Page 11 Section 3. Operating the Appliance 3.1. Switching on the Appliance Allow the appliance to stand for a minimum of 4 hours after installation. Plug in the appliance and switch on at the mains supply. Set the thermostat control to the required setting as detailed in the Temperature Control section (3.2.).
- Page 12 3.4. Energy Saving Advice - Do not install the appliance close to sources of heat, such as a cooker, dishwasher or radiator. - Locate the appliance in a cool well-ventilated room and make sure that the air vents are clear. - Try to avoid keeping the door open for a long time, warm air will enter the cabinet and may cause a build up of ice as well as affecting the energy consumption.
- Page 13 Section 4. Maintenance Before any maintenance or cleaning work is carried out, DISCONNECT the appliance from the ELECTRICITY supply. 4.1. Internal Cleaning Clean the interior and accessories with warm water and bicarbonate of soda (5ml to 0.5 litre of water). Rinse and dry thoroughly. Do not use detergents, abrasive powders, highly perfumed cleaning products, wax polishes or cleaning products containing bleach or alcohol.
- Page 14 4.4. When the appliance is not in use When the appliance is not in use for long periods, remove the contents, disconnect from the electricity supply and clean the appliance, leaving the door ajar until you wish to use the appliance again.
- Page 15 4.5. Reversing the Door The door opening can be reversed from “right hand hinged” to “left hand hinged” if required. If your appliance is supplied “left hand hinged” simply reverse the following procedure. Warning! When reversing the door, the appliance must not be connected to the mains. Remove the plug from the mains beforehand.
- Page 16 4.6. Changing the Light Bulb · Unplug the appliance from the power supply · Remove the refrigerator light cover (A) by pressing the hooks placed on both sides of the cover · Replace the bulb (B) with a ‘like for like’ unit, maximum 15W ·...
- Page 17 If after the previous checks there is still a fault, please contact the Repairtech Service Help-line below. Please ensure that you have the model number, serial number, date of purchase and retailers information available before you make the call. SERVICE HELP-LINE Should your appliance develop a fault, please call the Repairtech Service Helpline on: 01527-888133...
- Page 18 Insurance Any warranty provided with this product does not cover loss of fridge/freezer content . Any claim for loss, damage, costs or expenses of an indirect or consequential nature including any economic loss or damage to foodstuffs or any other goods is excluded.