Using the microphone
1
Make sure that the receiver is turned ON
Make sure that the [POWER] indicator on the wireless receiver / extension receiver
lights green.
Power indicator
2
Press the power switch on the microphone to turn it ON.
The [PWR] indicator on the microphone lights up.
When the microphone is turned ON, the audio
Important
collected by the microphone unit is transmitted.
If the [PWR] indicator on the microphone blinks red, the microphone is
not paired to a wireless receiver / extension receiver. Perform the steps
described in "Pairing" (page 20).
After use, return the power switch on the microphone to the OFF position.
Press the power switch once more to turn the microphone OFF. The [PWR] indicator
goes off.
Important
Do not place the microphone near the speakers. Doing so may cause
Important
howling and other loud noises which may cause injuries to the ears.
If the microphone moves out of the antenna range, the [PWR] indicator
blinks orange and the microphone stops audio transmission. Move the
microphone back into the antenna range to resume transmission. Refer to
the wireless receiver / extension receiver manual for specifics on the
wireless transmission range.
Keep a distance of at least 50 cm (19-5/8 inch) between this microphone and
other wireless microphones. Placing multiple microphones within 50 cm (19-
5/8 inch) of each other may cause transmission lag, audio dropouts, and noise.
28
* This illustration shows the WX-SR202P.
Power indicator
Power switch