Panasonic WX-ST400 Operating Instructions Manual page 21

Table of Contents

Advertisement

Available languages

Available languages

2
Set the wireless receiver / extension receiver to pairing mode
Make sure that the [POWER] indicator on the wireless receiver / extension receiver
lights green, then press for at least two seconds the [REG] button of the channel to
which you want to pair a microphone.
When the wireless receiver / extension receiver is in pairing mode, the [REG] indicator
of the channel whose [REG] button has been pressed will blink orange. Pairing mode
lasts for 30 seconds, so pair the microphone within this time.
Power indicator
3
Pair the microphone
With the microphone powered on, keep the [REG]
button pressed for at least two seconds to start pairing
(the [PWR] indicator will blink orange).
If pairing is completed successfully, the [PWR] indicator
on the microphone will switch to the normal status
according to the remaining battery level (green, orange,
or red), and the [REG] indicator on the paired channel
on the wireless receiver / extension receiver lights green
for one second and then goes off.
⿟ If pairing could not be completed successfully, the
[PWR] indicator on the microphone will blink red. In
that event, place the microphone as close as possible
to the antenna and try pairing it again. (Pairing may
Important
fail if the microphone is too far away from the antenna
or under bad connection conditions.)
4
Place the battery cover back on
Place the battery cover back onto the product.
⿟ While the microphone is in use, the [REG] button of the corresponding
channel on the wireless receiver or extension receiver is disabled. Turn the
currently paired microphone power OFF, then you can pair a different
microphone to the channel that is already in use.
⿟ The wireless receiver / extension receiver cannot enter pairing mode on
multiple channels simultaneously.
⿟ When a channel on the wireless receiver / extension receiver is in pairing
mode, all other channels can still be used as normal.
Register indicator
Register button
* This illustration shows
the WX-SR202P.
Power indicator
Register
button
21

Advertisement

Table of Contents
loading

This manual is also suitable for:

Wx-st400p

Table of Contents