Table of Contents
Advertisement
Installing the battery
1. Press the Push
cover down.
2. Place the accessory Li-Ion battery into the compartment until it is
locked by the latch. Note that the metallic contacts must be aligned
with the contacts in the compartment.
3. After the battery is properly installed, close the battery
compartment cover.
Charging the battery
approximately 3 hours to fully charge the battery by AC adapter.
1. Connect the cable.
Connect one end of the supplied AC adapter to the USB port of the
camcorder and the other end to a wall outlet.
OR
Connect one end of the supplied USB cable to the USB port of
the camcorder and the other end to a powered PC. Make sure the
camcorder is powered off.
2. The charging LED turns red and the charge starts.
3. When the battery pack is fully charged, the charging LED will turn green.
Inserting a memory card (optional)
To insert a memory card, do the following:
(1) Press the Push
To remove the memory card, gently push the card and it will pop
up. Then pull the card out of the slot.
Turning on/off your camcorder
Open the LCD monitor or press and hold down the Power button for 1 second to turn on
the camcorder.
To turn off the camcorder, press and hold down the Power button for 1 ~ 3 seconds or
close the LCD monitor.
Get user manuals:
See SafeManuals.com
When using a PC to charge the battery, do not power on the camcorder, or
the charge will stop.
cover down.
the top until the card reaches the bottom of the slot.
If the camcorder stays inactive for a long period of time, it may automatically
shut down due to the Auto-Off setting.
3
Advertisement
Table of Contents
