Example; Adding New Remote Controls - Clifford Sabre II Owner's Manual

# of
Factory
Feature momentary
setting
presses
Add a new
remote to
channel 3 13
—
(silent
arm/disarm)
Erase all
15
—
channels
Valet Code 16
2
Example : To change the AutoArming feature from its factory
setting of "on" to "off," you would do the following:
Turn the ignition key to the ON position.
Enter your valet code, then immediately tap and release the
momentary side of the PlainView switch 4 times (you'll hear a
chirp each time you press to help you count to the total of 4
chirps).
Wait 3 seconds. The system will sound one more chirp to
confirm that the AutoArming setting is now off (1 chirp = off,
2 chirps = on).
Turn the ignition off. That's all there is to it! To change the
AutoArming setting back, just repeat the procedure.

Adding new remote controls

For other drivers in your family, or if you wish to control Clifford systems on your
other cars with the same remote control, you can buy additional remote controls
from any Clifford Dealer (or call our Customer Service Department at
800-824-3208) and program them into the system yourself. Each Sabre II will
respond to as many as four 3-channel ACG and/or 12-channel ACG remote
controls. To add a new remote control to the system, use the procedures noted in the
User-selectable features section on page 13 and above.
Secondary
completion
action
confirmation
Press remote control button 3
—
See Setting your own secret valet code on page 9.
14
Program
Result
Button 3/channel 3 code of
3 chirps the new remote control
has been memorized
All remote control codes
2 chirps have been erased; program
in new remote control(s)