Table of Contents
Advertisement
Quick Links
68" Fireplace Media
Console with 36"
Traditional Infrared
Electric KD Insert
ASSEMBLY, CARE & USE INSTRUCTIONS
MODEL # 1379KDI-36-290
Date Purchased _______________________
Questions, problems, missing parts? Before returning to your retailer, call our customer service
department at 1-704-461-2414 8:30 a.m. - 5 p.m., EST, Monday - Friday.
www.greentouchhome.com
1
Français p. 20
Español p. 39
Advertisement
Table of Contents
Related Manuals for Greentouch 1379KDI-36-290
Summary of Contents for Greentouch 1379KDI-36-290
- Page 1 Traditional Infrared Electric KD Insert ASSEMBLY, CARE & USE INSTRUCTIONS MODEL # 1379KDI-36-290 Date Purchased _______________________ Questions, problems, missing parts? Before returning to your retailer, call our customer service department at 1-704-461-2414 8:30 a.m. - 5 p.m., EST, Monday - Friday.
-
Page 2: Package Contents
PACKAGE CONTENTS PART DESCRIPTION QUANTITY PART DESCRIPTION QUANTITY Back Panel Center Shelf Fireplace Brick Wall Left Middle Wall Fire Log Right Middle Wall Fireplace Grate Left Outer Wall Remote Control (Battery Inside) Right Outer Wall Baffle Left Door Fireplace Glass Front Right Door Base Shelf... -
Page 3: Safety Information
HARDWARE CONTENTS (NOT SHOWN ACTUAL SIZE) PART DESCRIPTION QUANTITY PART DESCRIPTION QUANTITY Bolt Hinge Screw Back panel mounting Door Pull hardware Touch-up Pen Screw L-Bracket Long Bolt Shelf Pin Hinge SAFETY INFORMATION Please read and understand this entire manual before •... -
Page 4: Important Instructions
SAFETY INFORMATION (CONTINUED) Modifications not approved by the party responsible • DO NOT route cord under furniture or appliances. for compliance could void user’s authority to operate Arrange cord away from traffic areas and where it the equipment. will not be tripped over. •... - Page 5 SAFETY INFORMATION (CONTINUED) • To avoid electric shock, fire, or injury, review the • To disconnect this appliance, turn controls to the assembly instruction to confirm that the appropriate OFF position, then remove plug from outlet. • ONLY connect to properly grounded outlets. critical components and accessories are being used with the furnishing.
- Page 6 SAFETY INFORMATION (CONTINUED) Electrical Connection Grounding Instructions • A 15-Amp, 120-volt, 60 Hz circuit with a properly • This heater is for use on 120 volt. The cord has a grounded outlet is required. Preferably, the fireplace plug as shown below. See illustration or grounding will be on a dedicated circuit as other appliances instruction.
- Page 7 PREPARATION Before beginning assembly of product, make sure Estimated Assembly Time: 50 minutes all parts are present. Compare parts with package contents list and hardware contents list. If any part is Tools Required for Assembly (not missing or damaged, do not attempt to assemble the included): Phillips screwdriver product.
- Page 8 ASSEMBLY INSTRUCTIONS (CONTINUED) 3. Attach right outer wall (F) to the right side of base (S), Securing with two bolts (AA). Repeat for left outer wall (E). Hardware Used Bolt 4. As shown in the diagram, insert the center back panel (J) and back panels (K) along the grooves of the middle walls (C,D) and outer walls (E,F).
- Page 9 ASSEMBLY INSTRUCTIONS (CONTINUED) 6. Secure the back panels (K) and center back panel (J) to the product using the back panel mounting hardware (BB), screwing the screws by Phillips screwdriver (As shown in diagram 6). Hardware Used Back panel mounting x 16 hardware 7.
- Page 10 ASSEMBLY INSTRUCTIONS (CONTINUED) 9. Remove the film from the adhesive on the top of the fireplace grate (N) and place the fire log (M) on the center of the fireplace grate (N). 10. Attach two L-bracket (DD) onto the fireplace brick wall (L) using four screws (CC).
- Page 11 ASSEMBLY INSTRUCTIONS (CONTINUED) NOTE: Recommend customer clean fireplace glass front prior to moving to next step. 12. Insert the pins of the fireplace glass front (R) into the holes on the base (S). Push the top of the fireplace glass front (R) inward until the hole on each side of the frame is adjacent to the hole on both remote left middle wall and right middle wall panels.
- Page 12 ASSEMBLY INSTRUCTIONS (CONTINUED) 15. Place door pull (II) into predrilled hole on left door (G), securing with two door pull screws. Repeat for remaining door pull (II). Hardware Used Door Pull 16. Install the doors I. Loosen the screws on the hinge arms and plates pre-attached on the walls (E and F). II.
- Page 13 ASSEMBLY INSTRUCTIONS (CONTINUED) 17. If you need to adjust the doors, do so in the following manner. To adjust door up or down, loosen screws (a) on both hinges, adjust door, and retighten screws. To adjust door left or right, turn screws (b) on both hinges, in and out. To adjust door in or out, loosen screws (c) on both hinges, adjust door, and retighten screws.
- Page 14 OPERATING INSTRUCTIONS Control Panel Remote Control To use the remote control, first remove the plastic tab by gently pulling it out of remote control. Controls and Display The control panel will display the heater setting when the unit power is turned ON. Whichever control icon you press will display the current setting of the corresponding function.
- Page 15 OPERATING INSTRUCTIONS (CONTINUED) Heater Function • Press the HEATER ICON to display the current heater setting. • Press the HEATER ICON again to scroll down through the heater settings. Note: Long-hold the icon to quickly scroll through settings. • Set the heater to “HI” (High) to have the heater run continually. •...
-
Page 16: Care And Maintenance
CARE AND MAINTENANCE • Make sure the unit is turned OFF, unplugged and the heating elements of heater are cool whenever you are cleaning the heater or fireplace. • Clean the metal trim using a water-dampened soft, clean cloth. DO NOT use brass polish or household cleaners as these products will damage the metal trim. -
Page 17: Troubleshooting
TROUBLESHOOTING PROBLEM POSSIBLE CAUSE CORRECTIVE ACTION Error E1 displayed on The overheat sensor has Unplug unit, wait 15-20 minutes, then the sensor will reset control panel. been engaged. itself. Plug the unit back in and turn on the heater. If the problem persists, call customer service. -
Page 18: One-Year Limited Warranty
ONE-YEAR LIMITED WARRANTY The manufacturer warrants that your new electric fireplace is free from manufacturing and material defects for a period of one year from date of purchase, subject to the following conditions and limitations. Install and operate this electric fireplace in accordance with the installation and operating instructions furnished with the product at all times. -
Page 19: Replacement Parts List
EST, Monday - Friday. PART DESCRIPTION PART # Fireplace Brick Wall 1379KDI-36-290-INSERT WALL BRICK Fire Log FIRE LOG 4 Fireplace Grate GRATE D Remote Control RC-HE85EL01 Heater KDI-01-36 Baffle GRATE D BAFFLE Fireplace Glass Front 1379KDI-36-GLASS FRONT Hardware Pack (M-1108) 1379KDI-36-290-HARDWARE PACK...
Need help?
Do you have a question about the 1379KDI-36-290 and is the answer not in the manual?
Questions and answers