Saving A Preset - Electro-Harmonix Cathedral Stereo Reverb Manual

7. If you prefer you can tap in the delay time. To do so, tap the TAP/INFINITE
Footswitch two or more times. The delay time will be set to the average time
between taps.
Filtering the ECHO Repeats
8. Set the delay time for a long delay.
9. Turn the FEEDBACK knob up to 3 o'clock so that you hear numerous echoes
from one note.
10. Now turn DAMPING/TONE counter-clockwise to approximately 9 o'clock.
11. When you play a note, you will hear that the echoes sound filtered and each
echo is more filtered than the previous one. The filtering is reducing the high
frequencies in your notes, filtering out the treble.
12. Turn the DAMPING/TONE knob clockwise to 2 o'clock.
13. Now when you play a note, each echo will again sound filtered but this time the
low frequencies will be filtered. Each echo repeat will have less bass than the
previous echo.

Saving a PRESET

1. When you create a reverb space that you like, you can save the effect as a
preset.
2. To save a preset, press and hold down the MODE knob. You will need to hold
down MODE for at least 3 seconds.
3. After holding down the MODE knob for 2 seconds, all of the MODE LEDs will blink
for 1 second. After they stop blinking, the preset is saved and you can release
the MODE knob.
4. Upon releasing the MODE knob, the PRESET LED will light up to indicate that a
preset is currently loaded.
Loading a Preset
5. Turn the MODE knob to the mode LED where you saved the preset.
6. Press and release the MODE knob. The PRESET LED will light. Your preset is now
loaded.
7. The knob positions no longer represent the effect you hear.
4