Table of Contents
Advertisement
INSTALLATION GUIDE
Typical Feed Sensor Wiring
Feed sensors (ex.: CSD-1 Current Switch Detector) should be mounted inside the
controller enclosure with the feeder power wire running through the sensor loop. If a
single sensor monitors multiple feeder circuit, run the wires from all feeder groups the
same direction through the sensor loop.
The best use for a single feed sensor is monitoring your silo auger motor. This provides a
clear indication of all feed entering the building and it provides an alarm when the feed
silo is empty.
FIGURE NO. 3 Typical Feed Counter Wiring
SENSOR & COMM. BOARD
X1199
PRB13
PRB14 PRB15 PRB16
PRB17
PRB18 PRB19 PRB20
RELAY BOARD
X1184
NO C
NO C
NO C
NO C
NO
C
L1
L2/N
Page 44
Advertisement
Table of Contents
