Electrician's Notes - Genius iTouch Series Installation Manual

Hide thumbs

Table Of Contents

Table of Contents

(PROBE WIRING) SHIELDED WIRE AWG #22 WITH 16/30 STRANDING, 500ft

(150m) MAXIMUM LENGTH (Ex.: DECA 73-310).

For other probe, refer to specific probe manual for appropriate maximum length and

wire size or use AWG #22, 500ft (150m) MAXIMUM LENGTH.

(COMMUNICATION WIRING) SHIELDED, TWISTED PAIR (8 TWIST/FT). MAX

LENGTH FOR 350PF/M CABLE : 500FT (150M). MAX LENGTH FOR 89PF/M

CABLE : 820FT (250M).

HIGH VOLTAGE WIRE INSTALLED ACCORDING TO LOCAL WIRING CODE.

INSTALL

POTENTIOMETER WIRES) AT LEAST 12 INCHES (30cm) AWAY FROM HIGH

VOLTAGE WIRES (120/230VAC, 24VDC). ALWAYS CROSS HIGH AND LOW

VOLTAGE WIRES AT A 90-DEGREE ANGLE.

RELAYS : 20A @250 VAC RESISTIVE, MOTOR 2HP @250 VAC, 1HP 120 VAC

AT EACH OUTPUT.

TRIAC : THE CURRENT SHALL NOT EXCEED 8A AT EACH OUTPUT. SEE

SPECIFICATIONS SECTION FOR DETAILS.

MAXIMUM 2 WIRES OF SAME SIZE PER BLACK TERMINAL, NO BIGGER

THAN AWG #12, NO SMALLER THAN AWG #22.

1 WIRE ONLY PER GREEN TERMINAL. USE WIRE CONNECTOR IF YOU

WANT TO CONNECT MORE THAN 1 WIRE, NO BIGGER THAN AWG #12, NO

SMALLER THAN AWG #28.

CHECK INSTALLATION SECTION FOR ALARM WIRING.

USE SHIELD FOR SHIELDING PURPOSE ONLY. CONNECT 1 END AND 1 END

ONLY OF THE SHIELD TO THE CONTROL CIRCUIT COMMON END

LEAVE BOTH ENDS OF THE SHIELD UNCONNECTED. NEVER CONNECT

BOTH ENDS OF THE SHIELD TO COMMON

ALL PROBES AND POTENTIOMETERS IS MANDATORY.

JP1 - JUMPER MUST BE INSTALLED ON PIN 2-3 = STANDARD AND

JP2 - JUMPER MUST BE INSTALLED ON PIN 2-3 = STANDARD

THE CURRENT SHALL NOT EXCEED 13.5A AT EACH OUTPUT (OUT 1-2) FOR

A RESISTIVE LOAD (LIGHTS) AND FOR AN INDUCTIVE LOAD (FANS), THE

CURRENT SHALL NOT EXCEED 12A AT EACH OUTPUT (OUT 1-2).

VARIABLE BOARD (X1279) OF THE V4 MODULE REQUIRES THE SAME

PHASE AND VOLTAGE AS THE MODULE MAIN BOARD (X1335).

REFER TO FIGURE 11 IN THIS MANUAL FOR WIRING DETAILS.