Table of Contents
Advertisement
4. Receive Your First Messages
4.1 Configuration Parameters
A set of configurable parameters defines the modes, behaviors and frequency of the
messages sent from UnaBell LTE-M:
Parameter
Mode
Uplink Frequency
Downlink Interval
Occupancy Duration
Command
FOTA URL
Config external I/O
detection mode
Description
There are 6 modes available on UnaBell LTE-M:
• Timer
• Event
• Event + Timer
• Event + Heartbeat
• Occupancy
• Occupancy + Heartbeat
In Timer Mode and Heartbeat Modes, this sets the
number of timer messages or heartbeat messages
per day
The duration for the device to send a downlink
request to initiate the downlink process
In Occupancy Modes, this sets the period of time
from which the debounce timer starts to countdown
so if no state change is detected past the
occupancy duration (and the timer countdown
reaches 00:00) then the device identifies the state
has changed.
For example, if this is set at 10 secs, then device will
only change state after it detects the same state for
longer than 10 secs.
There are 4 commands available on UnaBell LTE-M:
●No command
●Full-band scan
●eSIM OTA
●FOTA
Enter the URL for the FOTA process
There are 4 external I/O detection modes available
on UnaBell LTE-M:
●Off
●Edge
●Pulse
●Temperature Sensor (DS18B20)
UnaBell LTE-M User Guide
Example Value
Event
4
12 Hours
900 Secs
No Command
URL
Off
11
Advertisement
Table of Contents
