Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for UnaBiz UnaBell LTE-M
Summary of Contents for UnaBiz UnaBell LTE-M
-
Page 2: Table Of Contents
2.4.3. 2 Wire Accessory 3. TROUBLESHOOTING Appendix Copyright Information Service and Support Limitation of Liability Declaration and Safety Statement Federal Communications Commission Statement FCC Radio Frequency (RF) Exposure Caution Statement Declaration of Conformity CE Marking Safety Notice UnaBell LTE-M User Manual... -
Page 3: Activation And Installation
1. If you use the Plastic Nano SIM, the device will use it for network connection instead of eSIM. 2. It might take up to 5 minutes if the device is connecting to a new network in a new region. 3. Be sure to put the casing back. UnaBell LTE-M User Manual... - Page 4 ● You can tie a string or rope around the hole on the bottom casing of the device and hang it on other items (e.g. a doorknob) ● Please always install the device with the top facing outwards and keep it away from metal or obstacles UnaBell LTE-M User Manual...
-
Page 5: Product Introduction
1. PRODUCT INTRODUCTION UnaBell LTE-M is a battery-powered smart button that can be configured to send messages and trigger actions for a variety of applications, which can last at least 2,000 clicks. The device is also dust and water resistant. -
Page 6: Features
● Local Network: eSIM or Nano SIM can be used based on your local network provider ● Firmware Over-the-Air (FOTA) Update: via LTE-M network to update device firmware ● UnaConnect Compatible: UnaBell LTE-M sends data through the LTE network and is natively received by the UnaConnect IoT Middleware for data parsing, configuration, enrichment and connection to end-points ●... -
Page 7: Specifications
117 x 40 x 26.5mm Weight 78g (without batteries) Dust & Water Proof IP54 casing protection External Connector 3.5 mm audio jack Casing Color White top casing & black Operating -10 to 60 degree Celsius Temperature UnaBell LTE-M User Manual... - Page 8 Occupancy Mode to send a message at the start and end of a state. For example, this can be used with the 2-wire accessory to connect to pressure sensors to detect the state of a seat (occupied/vacant) UnaBell LTE-M User Manual...
-
Page 9: Click Action And Led Indicators
Network Connecting Slow Blinking Green Data Transmitting Fast Blinking ● Green Data Transmission Completed ● 1 Long ON Communication Success ● Data Transmission ERROR ● Communication Failed 1 Long ON ● Network ERROR Low Battery Fast Blinking UnaBell LTE-M User Manual... -
Page 10: Monitor And Configure The Product
1. Login https://console.unaconnect.io/ with the credential provided by UnaBiz 2. Click on the device group containing your devices 3. Click on ‘Devices’ on the left navigation bar 4. Click on the device for data information and configuration ●... -
Page 11: Event Data
The Event Data tab displays all the messages containing descriptions of the events that are device-related such as downlink messages, downlink acknowledgement messages, Sigfox network error messages (example, a break in sequence message) along with the timestamp of these events UnaBell LTE-M User Manual... -
Page 12: Device Operation
Pulse Mode In pulse mode, the two-wire accessory can be used as an extension It shows the status of accessories: Rising/Falling Edge Reed Switch: the magnet is away from it/next to it Two Wire: disconnected/connected UnaBell LTE-M User Manual... - Page 13 This command is to search the network which has better Full-band Scan connectivity eSIM OTA This command is to update the contract or information of eSIM FOTA This command is to update the firmware via LTE-M network UnaBell LTE-M User Manual...
-
Page 14: Message Type
2.2.1. Downlink Messages A downlink message is sent from the UnaConnect platform to UnaBell LTE-M; the device initiates the downlink process by sending an uplink message with current device information to the cloud platform for downlink request, when the cloud platform receives the downlink request, it will send a downlink message to update the latest configuration set in UnaConnect to the device. - Page 15 The options are: ● Rising edge or occupied Event mask All event triggers enabled ● Falling edge or vacant ● Short click ● Long click ● Double short click ● Extra-long click UnaBell LTE-M User Manual...
-
Page 16: Uplink Messages
2.2.2. Uplink Messages UnaBell LTE-M supports 6 operation modes, each with its corresponding uplink message type, that could be configured by the user on the UnaConnect platform: ● Event ● Timer ● Event + Timer ● Event + Heartbeat ● Occupancy ●... -
Page 17: Operation Modes
● Uplink frequency: from 1 to 144 messages per 24 hours ● Summary of number of clicks detected: Edge, Single, Double, Long, Extra Long Note: If the Temperature Sensor is connected as the external connector, then the temperature values will be sent in timer messages UnaBell LTE-M User Manual... -
Page 18: Event + Timer Mode And Messages
The uplink message for Event + Heartbeat mode contains the following data: ● Message type: Event + Heartbeat ● Sequence number: counter from 0 to 4095 ● Battery voltage: remaining voltage measured in mV ● Enabled detection type: Rising edge, Falling edge, Single, Double, Long, Extra Long UnaBell LTE-M User Manual... -
Page 19: Occupancy Mode And Messages
● Message type: Occupancy + Heartbeat ● Sequence number: counter from 0 to 4095 ● Battery voltage: remaining voltage measured in mV ● Sensor status: status of external I/O connector configured as Pulse or Edge mode UnaBell LTE-M User Manual... -
Page 20: External I/O
2.4. External I/O To fulfill an even wider range of applications and use cases, UnaBell LTE-M may also act as a battery-powered gateway when used with its corresponding plug-and-play accessories in addition to the embedded button on the device. The configuration in UC should be updated to the accessory that is plugged into the device. -
Page 21: Temperature Probe Accessory
An example scenario is that a 2 wire pressure sensor customized by the user is connected to the UnaBell LTE-M to detect the state of a seat. The edge detection in occupancy mode detects when the pressure is applied and sends an 'occupied' message, then ignores other triggers from the sensor for a pre-defined period of time (occupancy duration), then checks if the pressure is still being applied. -
Page 22: Troubleshooting
LTE-M network again. 3. The device is not behaving according to its configuration All the configurations for UnaBell LTE-M can be defined on the UnaConnect platform. The Downlink Interval (DI) defines how often the device performs a downlink process with the cloud platform to update the configurations. -
Page 23: Appendix
LOSS OF PROFITS, LOSS OF BUSINESS, LOSS OF USE OR DATA, INTERRUPTION OF BUSINESS AND THE LIKE), EVEN IF UNABIZ HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES ARISING FROM ANY DEFECT OR ERROR IN THIS MANUAL OR PRODUCT. -
Page 24: Limitation Of Liability
Limitation of Liability In no event shall UnaBiz be liable to customer, any customer of customer or any third party for any loss of use, revenue or profit or loss of data or diminution in value, or for any consequential, indirect, incidental, special, exemplary or punitive damages whether arising... -
Page 25: Declaration And Safety Statement
FCC Radio Frequency (RF) Exposure Caution Statement This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20 cm between the radiator and a human body. UnaBell LTE-M User Manual... -
Page 26: Declaration Of Conformity
Power (dBm) Band 3 Band 8 Band 20 Band 28 SW Version: V2116 CE Marking RF Exposure Statement The minimum distance between the user and/or any bystander and the radiating structure of the transmitter is 20cm. UnaBell LTE-M User Manual... -
Page 27: Safety Notice
● Children should be supervised to ensure they do not play with the device and its parts. ● Please read and follow the instructions about replacing the batteries. There is a risk of explosion if the battery is replaced by an incorrect type. UnaBell LTE-M User Manual...