Advertisement
Assembly
1.
Screw the two feet on each side of the base with 4 M10×25 screws, 4 10-mm washers and 4 10-
mm nuts, then place the column-frame assembly on its feet.
2. Remove the two screws securing the top clamp bracket and slide it off the pole.
A
B
C
3. Slide the lower bracket down the column. Make sure that the adapter slides over the cylinder
and is pushed all the way down. Tighten the screw of the adapter.
4. Refit the upper clamp support.
D
E
F
G
H
5. Insert the foot pedal into the handle sleeve on the hydraulic cylinder and secure it with the screw.
6. Loosen the screw on the upper clamp and insert the upper clamp. Tighten the screw again to
secure the upper clamp.
7. The spring compressor is now ready for use.
https://www.XPOtool.com
The Tool Experts
Screws
Remove the screws
Push off the bar
Lower support bracket
Adaptor
Screw
Slide on
Refit bolts
Item 63295
Page 6
04 2022-1
Advertisement
