Advertisement
Quick Links
Operation Manual
Hydraulic Spring Compressor
63295
Illustration similar, may vary depending on model
Read and follow the operating instructions and safety information before using for the first time.
Technical changes reserved!
Due to further developments, illustrations, functioning steps, and technical data can differ insignificantly.
Updating the documentation
If you have suggestions for improvement or have found any irregularities, please contact us.
Advertisement
Related Manuals for WilTec XPOtool 63295
Summary of Contents for WilTec XPOtool 63295
- Page 1 Operation Manual Hydraulic Spring Compressor 63295 Illustration similar, may vary depending on model Read and follow the operating instructions and safety information before using for the first time. Technical changes reserved! Due to further developments, illustrations, functioning steps, and technical data can differ insignificantly. Updating the documentation If you have suggestions for improvement or have found any irregularities, please contact us.
- Page 2 All rights re- served. The WilTec Wildanger Technik GmbH cannot be held accountable for any possible mistakes in this operating manual, nor in the diagrams and figures shown.
- Page 3 Introduction Thank you for purchasing this quality product. To minimise the risk of injury we urge that our clients take some basic safety precautions when using this device. Please read the operation instruc- tions carefully and make sure you have understood its content. Keep these operation instructions safe.
- Page 4 Parts and part designations № Name Column/hydraulic cylinder assembly Upper clamp Lower support bracket Foot (×2) Bolt M10×25 (×4), 10 mm nut (×4), & 10 mm washer (×4) Foot pedal https://www.XPOtool.com Item 63295 Page 4 The Tool Experts 04 2022-1...
- Page 5 № Name Foot Lower support bracket Upper clamp Upper clamp support Hydraulic ram Foot pedal Release pedal https://www.XPOtool.com Item 63295 Page 5 The Tool Experts 04 2022-1...
- Page 6 Assembly Screw the two feet on each side of the base with 4 M10×25 screws, 4 10-mm washers and 4 10- mm nuts, then place the column-frame assembly on its feet. 2. Remove the two screws securing the top clamp bracket and slide it off the pole. Screws Remove the screws Push off the bar...
- Page 7 Foot pedal Handle sleeve Upper clamp Bolt Operating Instructions Bleeding Note! Bleed the spring compressor before use! Lower the piston of the hydraulic cylinder to its lowest position (press down and hold the release pedal until it reaches its lowest position). 2.
-
Page 8: Troubleshooting
Maintenance • Check the cylinder regularly for signs of rust or corrosion. Clean exposed areas with a clean, oiled cloth. Attention! Never use sandpaper or abrasives on these surfaces! • Coating the pivot points, axles, and hinges with light lubricating oil helps to prevent rust and ensure that the foot pedal, drain pedal, and pump assemblies move freely. - Page 9 Exploded view № Name Bolt Foot Frame Threaded knob Adjustable strut arm Bushing Lower support bracket Retaining ring https://www.XPOtool.com Item 63295 Page 9 The Tool Experts 04 2022-1...
- Page 10 Release pedal Washer Washer Important notice: The reprint or reproduction, even of excerpts, and any commercial use, even in part, of this instruction manual require the written permission of WilTec Wildanger Technik GmbH. https://www.XPOtool.com Item 63295 Page 10 The Tool Experts...