Roland CY-15R Owner's Manual page 5

Set up
Mounting on the Stand
1. Use a commercially available drum key to tighten
the stopper bolt.
The stopper keeps the V-Cymbal from turning, and prevents
the cables from catching or getting tangled on the stand.
fig.04.e.eps
Stopper
(Be sure to orient
it correctly)
2. Position the Roland logo on the farther side, as
viewed from the performer.
3. Tighten the felt washer and the wing nut to obtain
the desired movement.
fig.05.e.eps
Wing Nut
4. Secure the cables in place with the cable tie, while
leaving some slack in the cables to ensure that they
are not pulled by the movement of the cymbal
units when struck.
fig.06.e.eps
Wind the
cable tie
twice
Tighten it
not to slip
* Take care to ensure that the cables do not touch the cymbal units and/
or the stand. A cable touching a cymbal unit or a stand may cause
double sounding or other incorrect operation.
* Double sounding may occur if the wing nut is loose.
* Use the included felt washer and wing nut.
Tighten the bolt with a
commercially available
drum key
Position the Roland logo
on the opposite side of
the playing area
Felt Washer
Leave some
slack in the
cable(s)
Turn back to
fix the cable(s)
Connecting to a Sound Module
* To prevent malfunction and/or damage to speakers or other devices,
always turn down the volume, and turn off the power on all devices
before making any connections.
Use the supplied connection cables (stereo) to make the
connections. If monaural cables are used, edge shots, bell
shots, and choke play cannot be supported.
Connect the L-shaped plug of the included cable to the CY-
15R/14C.
The CY-14C has no BOW/BELL output. Make the connection
to the BOW/EDGE output.
fig.08.eps
Set Up Example : Connecting to the TD-20
Ride
CY-15R
BOW / BELL
Output Jack
BOW / EDGE
Output Jack
EDGE
RIDE
About three-way triggering (CY-15R only)
The CY-15R can take advantage of your drum sound
module's three-way triggering functionality to allow you to
play bow, bell, and edge separately.
Connect the two outputs BOW/BELL and BOW/EDGE to the
drum sound module at the same time.
For details on the connection method and settings, refer to
the owner's manual for your drum sound module.
* If you won't be using the three-way triggering functionality, connect
either the BOW/BELL output or the BOW/EDGE output (not both) to
your drum sound module.
Crash
CY-14C
TD-20 Rear Panel
CRASH
5