Table of Contents
Advertisement
INSTALLATION MENU
NOTE
•
Some features described in the Installation manual may not be supported in certain models.
Signage Setup Menu
Use this menu to configure the digital signage after installation.
Power On Status
•
You can select the operating status of the monitor when the main power is switched on.
•
You can select from among PWR, STD, and LST.
•
PWR sets the status of the monitor to On whenever the main power is switched on.
•
STD sets the status of the monitor to Standby when the main power is switched on.
•
LST sets the status of the monitor back to its previous status.
IR Operation
•
If you set IR Operation to Normal, you can use the remote control.
•
If you set IR Operation to Power Key Only, you can only use the Power Key.
•
If you set IR Operation to Block All, you cannot use the remote control. (Power On feature is available.)
Local Key Operation
•
If you set Local Key Operation to Normal, you can use the Local Key.
•
If you set Local Key Operation to Power Key Only, you can only use the Power Key.
•
If you set Local Key Operation to Block All, you cannot use the Local Key. (Power On feature is available.)
Wake On LAN
•
You can set whether to use the Wake On LAN feature.
•
You can set this option to On or Off.
•
If you set this option to On, the Wake On LAN feature is enabled and you can turn on the product remotely via LAN.
•
If you set this option to Off, the Wake On LAN feature is disabled.
LAN Daisy Chain
•
LAN Daisy Chain forms a daisy chain of LAN ports so that even if you connect only one monitor set to a network, the
other sets in the daisy are connected to the network.
•
The first set in the daisy chain must be connected to a network through a port that is not being used for the daisy
chain.
5
Advertisement
Chapters
Table of Contents
