Operation - Craftsman P205 Operator's Manual

WARNING:
Always check the chain tension and adjust as
necessary before beginning operation. Refer to Adjusting the
Chain Tension in the Maintenance section.
WARNING:
Make sure the chain oil reservoir is full
before operation. Check the oil level constantly so that it
does not drop below half full. Make sure the chain oil
adjustment screw is set appropriately. Refer to Setting the
Chain Oil Adjustment Screw in the Maintenance section.
The saw chain must be continuously coated with oil to
function properly.
WARNING:
Always wear appropriate eye, hearing, hand,
foot and body protection to reduce the risk of injury when
operating this unit. Wear head protection. Use a full face
shield when needed. Refer to the Safety section for
appropriate safety equipment information.
PREPARING THE WORK AREA
• Clear the area of children, bystanders and pets; keep them
outside a 50-foot (15 m) radius, at a minimum. Even then, they
are still at risk from thrown objects. Encourage bystanders to
wear eye protection. If you are approached, stop the unit
immediately.
• Keep the work area clean. Cluttered areas invite injuries. Do not
start cutting until the work area is clear and free from
obstructions. Make sure there is secure footing and a planned
retreat path from falling branches.
• Do not cut near electrical cables or power lines. Keep at least 50
feet (15 m) away from all power lines.
• Use the unit only in daylight or good artificial light.
HOLDING THE UNIT
• Always grip the unit firmly with both hands when the unit is running.
• Hold the shaft grip with the right hand. Keep the right arm
slightly bent.
• Hold the handle with the left hand. Keep the left arm straight.
• Hold the unit at waist level.
• Stand in a stable position with feet apart and firmly planted.
• Do not extend arms above shoulder height. Do not overreach.
• When carrying the pole saw from one place to another, hold it at
the balance point and keep the guide bar pointed to the rear.

OPERATION

WARNING:
use a pole saw to limb or buck a fallen tree. Use a chain
saw for these applications.
WARNING:
ladder unless specifically trained to do so.
WARNING:
Always wear appropriate head protection. Plan an escape
route away from falling limbs. Do not stand, or position any
body parts, directly below the branch being cut.
16
Do not use a pole saw to fell a tree. Do not
Do not operate the unit in a tree or on a
Falling branches can cause serious injury.