Installation And Start-Up; Beginning The Terminal Operation - Lanex TM-77 Operating Manual

5.3

Installation and start-up

In order to start up the supervision software, VT100 terminal or a VT100 terminal
emulation program should be correctly set up.
The tables below show examples of TERM95 and HYPERTERMINAL setup. If another
program is used, the user should set the appropriate parameters based on the user manual
of the program:
Table 10. VT100 terminal settings for "TERM95" program
Table 11. VT100 terminal settings for "HYPER TERMINAL" program
5.4

Beginning the terminal operation

After the device is started up and RS-232 interfaces are connected, enter the START command
and press the ENTER button. The command may be entered in small or capital letters.
When the command is identified, TM-77 opens the first window specifying the device type
and its address. Then the password entry window opens. It allows the user to enter the password
protecting from unauthorized access to the device. If the password is not active, it is sufficient
to press ENTER.
IOA77-1F
4 E1/G.703 P
X LESIOCHRONOUS
O
PERATING
Transmission speed
Data bits
Parity
Stop bits
Flow control
Emulation
TERM95
Speed
number of data bits
number of stop bits
flow control
local echo
terminal type
HYPERTERMINAL
bits per second
Data bits
Parity
Stop bits
flow control
Font
local echo of entered characters
M
ULTIPLEXER
M
ANUAL
9600
8
none
1
none
VT100
21
9600
8
1
none
none
VT100
9600
8
none
1
none
terminal
none
May 2007