Remote Valet Mode - Clifford Intelliguard 770 Owner's Manual

The LED status indicator will light steadily if you are entering Valet
Mode and will turn off if you are exiting Valet
To exit Valet Mode:
®
remote valet ®
The operations described in this section refer to remote buttons.
Remember, the buttons used in all the instructions in this guide corre-
spond to a Standard Configuration remote. This may not be how your
remote is set up.
To enter Valet ® Mode, press
LED status indicator will light solid if you are entering Valet
will turn off if you are exiting Valet
© 2 0 0 6 d i re c t e d e l e c t ro n i c s
1. Turn the ignition on.
2. Enter PIN code (factory setting is 2).
3. After the last digit of the pin code is entered:
a. To disarm the system: press and release
b. To enter valet
three seconds.
1. Turn the ignition on.
2. Enter PIN code.
3. After the last digit press
The LED will turn off.
mode
® mode: Press and hold
Mode.
®
twice and then
Mode.
®
.
for
®
for one second.
. The
® Mode, or
13