Table of Contents
Advertisement
U3042AE08
Test Set I/O Address and Data using Control Interface with N5230C or N5242A
An Instrument Preset will reset all of the fields to their default settings.
NOTE
Enable Interface Control:
Enables and disables ALL Interface Control communication. When cleared (default
setting) Interface Control is disabled and NO data is sent. To send data, the individual
interfaces must also be enabled.
Test Set I/O Control (address data):
Provides control of the test set I/O Interface on the rear panel of the PNA-X. Used to
control your test set.
Positive integer is used to select switch position or state of DUT control interface line.
Address and data are separated by a period. Entries should be separated by a new line, or
carriage return.The front panel Enter key inserts a new line into the field. The number of
test set I/O entries that can be entered is limited by the available memory of the PNA-X.
See
"Test Set I/O Interface Commands" on page
0.0
16.1
32.2
User's Guide U3042-90002
This Manual:http://www.manuallib.com/agilent/u3042ae08-test-set-user-guide.html
If an error is encountered when sending Interface Control data, an error
message is displayed on the screen and the Channel Trigger State is set to
Hold. You must fix the condition that caused the error, then change the
Channel Trigger State to its original setting.
Controlling the Test Set with N5230C or N5242A
43.
33
Advertisement
Table of Contents
