Table of Contents
Advertisement
Operation
After completing the installation and setup, the Solo-Call system will begin working
correctly after both the transmitter and pager units have been powered off and on
again, as follows:
Turn the transmitter unit off and on by sliding the power switch upwards
1.
and then downwards;
2.
Turn the pager unit off and on by sliding the multi-position switch upwards
and downwards to either:
Position 1: Audio Alert;
a.
Position 2: Vibration Alert;
b.
c.
Position 3: Audio and Vibration Alert.
Chair or Bed Mode
When set to Chair or Bed mode, the Solo-Call will alarm when pressure is relieved from
the mat as the patient leaves the chair/bed. The alarm will cease when pressure is
reapplied to the mat.
It is possible to temporarily suspend the alarm for 30 seconds by pressing the reset
button while the pager unit is alarming. After 30 seconds monitoring will resume.
Floor Mode
When set to Floor mode, the Solo-Call will alarm when pressure is applied to the mat,
detecting when a patient moves through a certain area. Once triggered, the pager unit
will continue to alarm until the reset button is pressed.
1510 Wireless Solo Call Instructions_160927.indd 5
27/09/2016 15:01:00
Advertisement
Table of Contents
