Table of Contents
Advertisement
Please carefully follow these setup instructions and test your new system thoroughly
before relying on it.
Pager Unit Charging
The Pager Unit should be thoroughly charged before first use, as follows:
1.
Plug the USB cable into a suitable USB adapter or socket (not supplied);
2.
Stand the charging dock on a firm surface and place the Pager Unit into the
recess;
3.
If necessary, gently push the Pager Unit home onto the charging pin;
4.
The battery charging LED will illuminate red to confirm the item is charging;
5.
When fully charged the battery charging LED will illuminate green;
When the battery runs low, the battery low LED will blink on the pager.
6.
Transmitter Battery Installation/Replacement
The transmitter uses 2 x AAA batteries (not supplied), inserted as follows:
Depress the lock pin and slide battery cover downwards;
1.
2.
If installed, remove existing batteries and dispose of responsibly;
3.
Insert 2 x AAA (1.5v) batteries, observing the correct polarity;
Replace the battery cover and slide upwards until the lock pin locates;
4.
When the batteries run low, the transmitter battery low LED will blink on
5.
both the pager and transmitter.
When not in use for a long period, the transmitter batteries should be removed to avoid
leakage. Please refer to Safety Warnings and Battery Guidance.
Pairing the Pager and Transmitter
The Solo-Call Pager and Transmitter must be uniquely paired together, avoiding false
alarms and allowing several units to be operated in the same area. The units may be
paired as follows:
1.
Remove the battery cover on both the Transmitter and Pager units by
depressing the lock pin and sliding the covers downward;
2.
Turn the transmitter unit on, by sliding the power switch downwards;
3.
Turn the pager unit on, by sliding the multi-position switch downwards to
position 1;
With the battery compartment of both units facing upwards, press the learn
4.
link button on each unit. The power light on each unit will flash rapidly to
confirm pairing has begun;
5.
Once paired, the power light on each unit will flash rapidly to confirm
pairing was successful;
Replace the battery cover on each unit and slide upwards until the lock pin
6.
locates.
The Solo-Call system has up to a 30 metre range between the transmitter and pager
units. As with any wireless signal, this will be reduced by obstacles such as thick walls
and steel beams.
To prevent any gap in monitoring, the Solo-Call system will check for a link between the
transmitter and pager every 30 seconds. If no link is detected for 3 successive tests,
the pager will alarm and the broken link LED will illuminate. In this instance, steps
should be taken to return within the wireless range before resetting or re-pairing the
Solo-Call system is required.
1510 Wireless Solo Call Instructions_160927.indd 3
27/09/2016 15:00:59
Advertisement
Table of Contents
