Installing The Stand - Sanyo LCD-40R40HD Service Manual

If the stand is provided, please read these instructions thoroughly before attempting this installation.
You must install your TV into the stand in order for it to stand upright on a cabinet or other flat surface. If you intend
to mount your TV on a wall or other vertical surface, you must remove the stand column.
Cautions:
Make sure that you handle your TV very carefully when attempting assembly or removal of the stand. If you are not
sure of your ability to do this, or of your ability to use the tools necessary to complete this job, refer to a professional
installer or service personnel. The manufacturer is not responsible for any damages or injuries that occur due to
mishandling or improper assembly.
The speaker is not intended to support the weight of your TV. Do not move or handle your TV by the speaker. This
can cause damage to your TV that is not covered by the manufacturer's warranty.
Before attempting assembly or removal of the stand, unplug the AC power cord.

Installing the stand

Locators
Stand
Locating grooves
NOTE:
The appearance of this product in these illustrations may differ from your actual product, and is for
comparative purposes only.
Appendix: Installing the Stand
To install the stand:
1. Remove the stand from the box and place it on a table or
2. Lay your TV flat (screen down) on the edge of a table or
bench. Make sure that you put down a soft cushion or
cloth so that your TV is not scratched.
3. Put the stand close to the TV back, align the stand with the
Secure with
four screws
To remove the stand from the TV, perform these steps in
reverse order.
bench.
You must pay attention to the direction of the stand. The
wide portion of the stand should go towards the front of
the TV.
TV by moving the stand steadily until the Stand Locators
align with the locating grooves on the stand. And align the
screw holes on the TV back with the holes in the stand,
then secure the stand to the TV with provided screws.