Gpio Genlock Example - 7th Sense Juggler 1 User Manual

21
Rear Panel Connections

GPIO Genlock Example

Example: Use an input VSync
In the Juggler system, the first in line is designated as providing the source for genlock.
In Compere
This first Juggler's GPIO:1 is set to be an output, using a video channel media input as its source, and
the signal it is sending as the V Sync is is receiving from this source (expressed as Rx:V Sync) (see
terms above).
Ø
See Compere 1.0-5 User Guide: GPIO Properties.
The next Juggler in line has its GPIO:2 set to be in input, in other words, simply receiving from the
attached cable.
Its GPIO:1 is set to be an output, using its GPIO:2 as its source (the signal need not be specified).
This is repeated down the line, the last of course not needing to be assigned a sending GPIO.
Connections
Five Jugglers would therefore be cabled as follows:
M611-1 Operating Juggler 1 Pixel Processor : User Guide © 2022 7thSense