Summary of Contents for FirstBuild ZVC48DCB1
- Page 1 INSTALLATION INSTRUCTIONS USE & CARE MANUAL Designer Hood Duct Cover ZVC48DCB1/ZVC48DCSS1 FirstBuild.com...
-
Page 2: Safety Information
See Warranty section for more information. Due to the weight and size of these vent hood covers and to reduce the risk of personal injury or damage to the product, TWO PEOPLE ARE REQUIRED FOR INSTALLATION OF THIS PRODUCT. FirstBuild.com... -
Page 3: Table Of Contents
14 ¹/16” 13 ¹/16” Tools & Materials Required (Not supplied) T20 Torx screwdriver Safety Glasses Electric or battery operated drill with Phillips driver Step ladder Safety Gloves Tape Measure Level Pencil FirstBuild.com... -
Page 4: Installation Clearances
If studs are not available near the installation location, use appropriate drywall anchors (not included) to ensure that the mounting plate is properly fastened into the wall. Unboxing Make sure to wear safety glasses and safety gloves before unboxing or using tools. Remove strapping Remove top cap Remove sleeve Lift product FirstBuild.com... -
Page 5: Locating The Mounting Plate
Confirm that the built-in 1/4” spacer on the bottom of the mounting plate is at or above the top of the vent hood. Push up the mounting plate against the ceiling. 1/4” spacer FirstBuild.com... -
Page 6: Fastening The Mounting Plate
Use an approved stainless steel polish or cleaner or warm, soapy water to wipe down your duct cover. Do not use abrasive pads, chemicals, or other cleaning methods that can damage the finish. Always wipe in the direction of the grain. FirstBuild.com... -
Page 7: Limited Warranty
For the period of 1 year from the date of the original purchase: If the duct cover fails due to a defect in materials or work- manship, during the limited one-year warranty, FirstBuild will either repair your product, replace your product with a new or remanufactured product, or refund the purchase price of the product at FirstBuild’s sole discretion.