Advertisement
Installation Clearances
This vent hood duct cover should only be installed above a 48" Monogram Designer Vent Hood. The duct cover shall
be spaced off of the top of the vent hood by a minimum of 1/4" to avoid the transfer of vibrations that may cause
unwanted noises.
Duct Cover
Advanced Planning
Wall Framing for Adequate Support
Adequate structural support must be provided to properly attach the mounting plate to the wall. Fastening into
studs is encouraged. If studs are not available near the installation location, use appropriate drywall anchors
(not included) to ensure that the mounting plate is properly fastened into the wall.
Unboxing
Make sure to wear safety glasses and safety gloves before unboxing or using tools.
Remove strapping
R2
Installation Instructions
Ceiling
Duct
1/4" MIN.
Remove top cap
FirstBuild.com
Remove sleeve
Lift product
4
Advertisement
