Advertisement
Step 3: Fasten the mounting plate
Use the included fasteners to attach the mounting
plate to the wall. Drive four (4) medium pan head
screws into studs where available, using an electric
drill. Predrill where necessary.
Use appropriate drywall anchoring hardware where studs
are not available.
Step 4: Fasten the duct cover
Place the duct cover around the mounting plate. Lift up
the duct cover or use shims underneath to lift the
duct up 1/4" to align the holes.
Use the included (4) shallow T20 Torx screws to
attach the duct cover to the mounting plate in
all four corners.
Do not over tighten the screws.
Cleaning your duct cover
Use an approved stainless steel polish or cleaner or warm, soapy water to wipe down your duct cover.
Do not use abrasive pads, chemicals, or other cleaning methods that can damage the finish.
Always wipe in the direction of the grain.
R2
Installation Instructions
Caring for your Duct Cover
FirstBuild.com
6
Advertisement
