Zero One Ti 48 Instruction Manual page 6

Ti48 Instruction Manual v1.2
2
and "I S " . The output device is set to S/PDIF by default. See Sections 12.2.1
and 12.2.7 (Device) in the User Manual for details on how to set­up the Ti48
to output via the I
2
the I S input.
2.3 If you are using another manufacturer's DAC, connect the Ti48 to the DAC
using a digital cable with a coaxial (RCA) connector (not included). The cable
should be connected to the Ti48 at the connector marked "SPDIF OUT". The
output device is set to S/PDIF by default. If this has been changed, see
Sections 12.2.1 and 12.2.7 (Device) for details on how to set­up the Ti48 to
output via the S/PDIF connection. Refer to the DAC's instruction manual for
how to connect the digital cable to the digital input of the DAC.
2.4 The remaining connectors on the back panel of the Ti48, marked : "SPDIF IN"
and "LINE : MIC / IN / OUT" are currently not operational.
3. START UP / SHUT DOWN
3.1 To start up the Ti48, press once – firmly ­ on the button labelled "ON" (back
panel). The Ti48's LCD screen will light up and the unit will take about 30
seconds to start up. It will be ready to accept remote control commands when
the screen reads :
CAUTION : When the Ti48 is running, do not press the "ON" button again.
Doing so may damage the hard­disk drives and will result in a longer delay on
start up the next time.
3.2 To shut down the Ti48, press the MENU key on the remote control handset to
access the mode menu , use the arrow keys to move the cursor down the menu
shown on the screen When the cursor is at "Shutdown", press the OK key.
01 Transport 01 Transport
MENU MENU
>CD Player >CD Player
HD Player HD Player
HD Editor HD Editor
2
S connection. Follow the instructions for the DAC to select
CD Player (stop) CD Player (stop)
Track 0/0 Track 0/0
Shutting down... Shutting down...
OK OK
00:00 00:00
01 Transport 01 Transport
Output Settings Output Settings
System Setup System Setup
>Shutdown >Shutdown
6