Ti48 Instruction Manual v1.2
To select upsampling mode,
move cursor to "Up mode"
Use arrow keys or OK to
scroll to –
"Up mode : HQ1"
To select upsampling rate,
move cursor to "Up rate"
Use arrow keys or OK to
scroll to –
"Up rate : 88200Hz"
To select dither, move cursor
to "Dither"
No action required as default
is – "Dither : None"
To select upsampling
wordlength, move cursor to
"Wordlen"
Use arrow keys or OK to
scroll to –
"Wordlen : 24bit"
To select phase, move cursor
to "Phase"
No action required as default
is – "Phase : Normal"
To select signal attenuation,
move cursor to "SigAttn"
Use arrow keys or OK to
scroll to –
"SigAttn : None"
To select output connection,
move cursor to "Device"
Use arrow keys or OK to
scroll to –
"Device : I2S"
Remote
Front Panel Screen
Control Key(s)
t
u
OK
OK
t
u
OK
OK
t
u
OK
OK
t
u
OK
OK
t
u
OK
OK
Output settings
Output settings
Output settings
>Up mode : HQ1
>Up mode : HQ1
>Up mode : HQ1
Up rate : 44100Hz
Up rate : 44100Hz
Up rate : 44100Hz
Dither : None
Dither : None
Dither : None
Output settings
Output settings
Output settings
Up mode : HQ1
Up mode : HQ1
Up mode : HQ1
> Up rate : 88200Hz
> Up rate : 88200Hz
> Up rate : 88200Hz
Dither : None
Dither : None
Dither : None
Output settings
Output settings
Output settings
> Wordlen : 24bit
> Wordlen : 24bit
> Wordlen : 24bit
Phase : Normal
Phase : Normal
Phase : Normal
Signal Attn : None
Signal Attn : None
Signal Attn : None
Output settings
Output settings
Wordlen : 24bit
Wordlen : 24bit
Phase : Normal
Phase : Normal
>Signal Attn : None
>Signal Attn : None
Output settings
Output settings
Phase : Normal
Phase : Normal
Signal Attn : None
Signal Attn : None
> Device : I2S
> Device : I2S
18