disarming indicates Tamper Alert, which is described in the
Diagnostics section of this guide.
Disarming Without a Transmitter
If your transmitter is lost or damaged, you can manually disarm
your vehicle security system. To disarm the system without a trans-
mitter, you must have the vehicle's ignition key and know where
the Valet switch is located. Be sure to check with your installer at
the time of installation for the location of the Valet switch.
now disarm. If the system does not disarm, you may have waited
too long to press the Valet switch; turn the ignition off and repeat
the process.
Location of Valet Switch_________________________________
Panic Mode
If you are threatened in or near your vehicle, you can press
for 1.5 seconds to trigger Panic Mode on your security system and
attract attention. The siren will sound and the parking lights will
flash for 30 seconds. To stop the Panic Mode at any time, press
again.
8
To disarm the security system,
turn the ignition key on and
press the Valet switch within 15
seconds. The system should
2004 Directed Electronics, Inc.
©
DRW-35