Backing U P M Y Content - Clickfree C2N User Manual

Clickfree C2N Home Backup Drive User Guide
Backing Up My Content (HD)
H I
OW DO START USING MY
If you are a non-administrator user, or are an administrator setting up a
Note:
Clickfree
administrator users" on page 53 before you begin using the C2N Home Backup
Drive for the first time.
If you have not yet backed up a computer onto the
the instructions below.
If you have previously backed up a computer onto the
use the BackupLink utility – see page 19.
B U
ACKING P A
1. Make sure that your computer is switched on and has finished starting up.
2. Log in, if that is what you normally do.
3. Attach the
end of the USB cable to the drive and the other end to a USB port on your computer.
A USB port usually looks like this:
beside it. USB ports are usually found at the front of a desktop computer, often in
pairs. On a laptop computer they may be at the back, front or side.
Please try to connect to a USB port on the computer itself -- using a USB hub may not
provide enough power.
When you connect the C2N Home Backup to your computer, some messages appear
on the screen telling you that your computer has found new hardware. The
messages may mention Clickfree, Disk drive, and/or CD-ROM drive. You don't
need to do anything about these messages. Most likely you will not see these
messages when you attach
4. Wait for the
your computer to recognize the
5. If your C2N Home Backup Drive is password protected, you are prompted to enter
the password to access the drive for backup or restore.
Copyright © 2010 Storage Appliance Corporation.
C
LICKFREE
C2N Home Backup Drive for a non-administrator user, see "Non-
C F T
OMPUTER THE IRST
Clickfree C2N Home Backup Drive to your computer by connecting one
Clickfree
Clickfree screen to appear. You may have to wait up to a full minute for
Clickfree
C2N H B
OME ACKUP
Clickfree
Clickfree
IME
and frequently has a symbol
the next time.
C2N Home Backup Drive.
Backing Up My Content (HD)
D ?
RIVE
C2N Home Backup, follow
C2N Home Backup,
15