Table of Contents
Advertisement
Power supply line, fuse or circuit
breaker
WARNING
• Always make sure that the power supply is
compliant with current safety standards.
Always install the air conditioner in
compliance with current local safety
standards.
• Always verify that a suitable grounding
connection is available.
• Verify that the voltage and fre uency of the
power supply comply with the specifications
and that the installed power is sufficient to
ensure the operation of any other domestic
appliance connected to the same electric
lines.
• Always verify that the cut-off and protection
switches are suitably dimensioned.
• Verify that the air conditioner is connected
to the power supply in accordance with the
instructions provided in the wiring diagram
included in the manual.
• Always verify that electric connections (cable
entry, section of leads, protections...) are
compliant with the electric specifications and
with the instructions provided in the wiring
scheme. Always verify that all connections
comply with the standards applicable to the
installation of air conditioners.
• Devices disconnected from the power supply
should be completely disconnected in the
condition of overvoltage category.
• Be sure not to perform power cable
modification, extension wiring, and multiple
wire connection.
– It may cause electric shock or fire due to
poor connection, poor insulation, or current
limit override.
– When extension wiring is re uired due
to power line damage, refer to Step 13
Optional: Extending the power cable in the
installation manual.
CAUTION
Make sure that you earth the cables.
• Do not connect the earth wire to the gas pipe,
water pipe, lighting rod or telephone wire. If
earthing is not complete, electric shock or fire
may occur.
Install the circuit breaker.
• If the circuit breaker is not installed, electric
shock or fire may occur.
Make sure that the condensed water dripping
from the drain hose runs out properly and
safely.
Install the power cable and communication
cable of the indoor and outdoor unit at least
(3.28 ft) 1 m away from the electric appliance.
Install the indoor unit away from lighting
apparatus using the ballast.
• If you use the wireless remote control,
reception error may occur due to the ballast
of the lighting apparatus.
• If the supply cord is damaged, it must be
replaced by the manufacturer, its service
agent or similarly ualified persons in order
to avoid a hazard.
5
English
Advertisement
Table of Contents
