Samsung AC BNNDCH Series Installation Manual page 4

Safety Information
• The air conditioner contains a refrigerant
that has to be disposed of as special waste.
At the end of its life cycle, the air conditioner
must be disposed of in authorized centres
or returned to the retailer so that it can be
disposed of correctly and safely.
• Wear protective e uipment (such as safety
gloves, goggles, and headgear) during
installation and maintenance works.
Installation/repair technicians may be injured
if protective e uipment is not properly
e uipped.
• This unit is a partial unit air conditioner,
complying with partial unit re uirements of
this International Standard, and must only
be connected to other units that have been
confirmed as complying to corresponding
partial unit re uirements of this International
Standard.
• This appliance is not intended for use by
persons (including children) with reduced
physical, sensory or mental capabilities,
or lack of experience and knowledge,
unless they have been given supervision or
instruction concerning use of the appliance
by a person responsible for their safety.
Children should be supervised to ensure that
they do not play with the appliance.
Installing the unit
WARNING
IMPORTANT: When installing the unit, always
remember to connect first the refrigerant
tubes, then the electrical lines.
• Always disassemble the electric lines before
the refrigerant tubes.
• Upon receipt, inspect the product to verify
that it has not been damaged during
transport. If the product appears damaged,
DO NOT INSTALL it and immediately report
the damage to the carrier or retailer (if the
installer or the authorized technician has
collected the material from the retailer.)
4
English
• After completing the installation, always
carry out a functional test and provide
the instructions on how to operate the air
conditioner to the user.
• Do not use the air conditioner in
environments with hazardous substances or
close to e uipment that release free flames
to avoid the occurrence of fires, explosions or
injuries.
• Our units must be installed in compliance
with the space specifications presented in
the installation manual in order to ensure
accessibility from both sides and allow
repairs or maintenance operations to be
carried out.
The unit s components must be accessible
and easy to disassemble without endangering
people and objects.
For this reason, where it is not observed as
indicated into the Installation Manual, the
cost necessary to reach and repair the unit (in
safety, as re uired by current regulations in
force) with slings, trucks, scaffolding or any
other means of elevation won t be considered
in-warranty and charged to end user.
• If any gas or impurities, except R-410A
refrigerant, come into the refrigerant pipe,
serious problem may occur and it may cause
injury.
Use the supplied accessories, specified
components and tools for the installation.
– Do not use the pipe and the installation
product used for the R-22 refrigerant.
– Failure to use the specified components
can cause product fall down, water
leakage, electrical shock, and fire. (The
pipe and flare components used for R-22
refrigerant must not be used)