Removal And Installation; Turbocharger Weight; Removing The Turbocharger; Table 2: A100-L Weights - ABB HT843525 Operation Manual

Operation Manual / 4 Product description / A100-L
2 Removal and installation / 2.1 Turbocharger weight
2

Removal and installation

2.1

Turbocharger weight

Lifting gear with a sufficient load limit must be used for removing and installing the tur-
bocharger. The following weight specification applies to the heaviest variant possible. De-
pending on the specification, the weight specified on the rating plate may be lower than the
standard value specified here.
Product
A165-L
A170-L
A175-L
A180-L
A185-L
A190-L
Table 2: A100-L Weights
2.2

Removing the turbocharger

WARNING
Risk of tipping
If the turbocharger is not sufficiently supported or not supported at all dur-
ing removal and installation, it may tip over and cause severe injury to per-
sonnel or accidents resulting in fatalities.
Support the turbocharger at a suitable location.
u
Secure with lifting gear wherever possible.
u
Wear safety helmet.
Loosen cable to speed sensor.
u
Disconnect all pipes according to the instructions of the enginebuilder.
u
Check lifting gear.
u
Fasten lifting gear on suspension eyes of the bearing casing and tauten.
u
© Copyright 2017 ABB. All rights reserved.
Weight [kg]
HZTL4034_EN
2300
3300
5600
7500
10500
13500
Revision K June 2017