Table of Contents
Advertisement
Please read the following section before installing your product:
Octagon's products are designed to be high in performance while
consuming very little power. In order to maintain this advantage,
CMOS circuitry is used.
CMOS chips have specific needs and some special requirements that
the user must be aware of. Read the following to help avoid damage to
your card from the use of CMOS chips.
≡ ≡
Using CMOS circuitry in industrial control
Industrial computers originally used LSTTL circuits. Because many
PC components are used in laptop computers, IC manufacturers are
exclusively using CMOS technology. Both TTL and CMOS have
failure mechanisms, but they are different. Described below are some
of the failures which are common to all manufacturers of CMOS
equipment. However, much of the information has been put in the
context of the Micro PC.
Octagon has developed a reliable database of customer–induced, field
failures. The average MTBF of Micro PC cards exceeds 11 years, yet
there are failures. Most failures have been identified as customer–
induced, but there is a small percentage that cannot be identified. As
expected, virtually all the failures occur when bringing up the first
system. On subsequent systems, the failure rate drops dramatically.
•
Approximately 20% of the returned cards are problem–free. These
cards, typically, have the wrong jumper settings or the customer
has problems with the software. This causes frustration for the
customer and incurs a testing charge from Octagon.
•
Of the remaining 80% of the cards, 90% of these cards fail due to
customer misuse and accident. Customers often cannot pinpoint
the cause of the misuse.
•
Therefore, 72% of the returned cards are damaged through some
type of misuse. Of the remaining 8%, Octagon is unable to
determine the cause of the failure and repairs these cards at no
charge if they are under warranty.
IMPORTANT!
3
Advertisement
Table of Contents
