Base Address; Table 1 W1 Jumper - Base Address Select - Octagon Systems 5624 User Manual

Plugging in the card incorrectly will destroy the card!
6. Power on the system.
When removing the 5624 from the backplane, make sure to first
disable power to your system.

Base address

The 5624 is configured at the factory to operate in most systems
without any jumper changes. Jumper block W1 defines the base
address. Refer to Figure 1 for the location of W1.
As shipped, the base address is 100H, which is jumper configuration
W1[1-2] [3-4] [5-6]. If there is another card in your system with a base
address of 100H, you must use a different base address for the 5624 or
the other expansion card.
To change the base address, change the jumper configuration
according to Table 1.
Table 1 W1 jumper – base address select
Pins Jumpered
[1-2] [3-4] [5-6]
[3-4] [5-6]
[1-2] [5-6]
[5-6]
[1-2] [3-4]
[3-4]
[1-2]
Not jumpered
* default
WARNING!
Base Address
100H
110H
120H
130H
140H
150H
160H
170H
13