Table of Contents
Advertisement
≡
5624 Installation
To install the 5624 card into a card cage:
1. Refer to the component diagram, Figure 1, for the location of various
connectors and jumpers before installing the 5624 card.
2. Verify the base address settings are correct for your application. Refer
to the Base Address section to select the base address.
3. Make sure power to the card cage is OFF.
4. Correctly orient the card. The components on the card should face
away from the power supply. Refer to Figure 2 for correct orientation
of the card into a backplane.
Figure 2
Edge connector orientation
5. Slide the 5624 card into the card cage. See Figure 3 for an illustration
of a 5624 card in a Micro PC card cage.
Figure 3
Populated Micro PC card cage
A31
B31
Micro PC
Passive
Back-plane
A1
B1
12
Card edge pins
A31 & B31
Micro PC card
Card edge pins
A1 & B1
Advertisement
Table of Contents
