Ferroli CONNECT Installation And Use Manual page 35

3) Coupling code
» See par. 5.3.
4) dhW temperatures (OpenTherm boilers only)
» Press the buttons
to enter.
» Press the buttons
» Press "set"
Note: If the thermostat receives the data from the boiler, then it displays this value,
otherwise the setting range is 30 – 60°C.
5) Information from the boiler (OpenTherm boilers only)
» Press the buttons
» When " " is displayed, it means the data is not available in the boiler
» Press "set"
No. information
1 Set temperature
2 Flow probe
3 Return probe
4 DHW temperature
5 Outside temperature
6 Power percentage
7 DHW draw
8 System pressure
to select the DHW temperature, and then "set"
to change the value.
or "mode" to return to the previous menu.
to select information, and then "set" to enter.
or "mode" to return to the previous menu.
4 digit on the display
th
1
2
3
4
5
6
7
8
cod. 3541S180 - Rev. 00 - 03/2019
35
EN